High-Quality Fenner link belt to replace the conventional motor to countershaft pulley 'Vee' belt on the Myford ML7.
Please note that due to its design, this belt will run higher on the pulley than the standard belt, this doesn't usually cause any problems but in some cases you may need to adjust the guard or motor position on the motor base (both are adjustable) to obtain the correct clearance between the inner guard and the belt.

Reduced Vibration/Noise – the segmented twist lock design of this type of belt acts as a vibration damper.
Longer Lasting - the composite polyurethane/polyester construction can outlast a conventional belt by many over.
High resistance to water, steam, oil and chemicals.
High resistance to extreme temperatures -40+240 deg F
Minimal Maintenance - Fit & Forget!

Tim
29/09/2023
Really helpful company , they were very quick to respond to my enquiry, about the belt , and delivery was equally fast . The belt itself is working very well and using it as a replacement takes away the job of removing the shaft holding the pulley wheels, Chuck etc to fit it .

Brian O
11/06/2021
Good price, prompt delivery, easy to fit. Have bought from Mike before and no doubt will do again.

Martin D
29/04/2021
Great service, thanks Martin.

Eric P
22/01/2021
These link type belts are quality, my ml7 has both fitted now and runs much quieter and seems to have more torque

Terry B
15/01/2021
Fitted my ML7 fine. Runs smoothly and quietly.

Anthony F
11/12/2020
I can't fault this companies service! Good products at good prices. will certainly continue to use in the future.

S VINE
18/02/2020
Nice belt. Quick delivery. No dramas or fuss. Will use again. Thankyou. Steve

S Thomas
03/10/2019
A reasonable price and prompt delivery, these link belts seem very good on initial use. Drive belt from motor to countershaft rubbed very slightly, however this was easily sorted by some slight adjustment of the guard. All in well worth it

B Tibbits
26/10/2018
Parts were shipped quickly and arrived well packaged, Thanks.